J. Kor. Inst. Fire Sci. Eng. Search

CLOSE


Journal of Korean Institute of Fire Science and Engineering 2006;20(3):21-28.
Published online September 30, 2006.
제연설비 성능시험방법의 표준화
곽지현
방재시험연구원, 방재설비부
Standardization of the Performance Test Procedure for Smoke Control System
Kwark Ji-Hyun
요약
화재 시 발생하는 고온의 유독가스는 가장 주요한 사망원인이며 공기와는 다른 유체역학적 특성을 가지므로 화재실의 형상과 특징에 맞는 제연방식이 필요하고 제연설비 각 구성품은 이에 따른 일정한 성능을 요구하게 되는데, 이를 위해서는 성능시험방법과 평가기준이 정립되어 있어야 한다. 이와 관련된 국내 기준은 서류에 의한 예비검사나 부위검사 등으로 되어 있어 성능위주의 평가방법 및 기준이 미비한 실정으로 국제규격과 비교해볼 때 여러 가지 문제점을 가지고 있다. 따라서 제연설비 주요 구성품인 제연경계벽, 배연구, 송풍기, 풍도, 방연댐퍼에 대해 국내외 기준을 비교 분석하고 문제점을 도출하여 각 구성품의 성능시험방법 표준화를 위한 방안을 제시하였다.
Abstract
Since hot toxic gas included in the fire is the most principal reason of the death and has the fluid mechanical characteristics unlike air, smoke control method appropriate for the figure and structure of a fire room is needed and each unit of the smoke control system requests high performance according to this characteristics, for which performance test procedures and evaluation criteria must be established. Domestic criteria involved with the smoke control consist of the pre-investigation by documents and the part inspection, which has lots of problems because they are far from the performance based evaluation method compared with the references of developed countries. Consequently, domestic and international references were compared and analyzed, problems being emerged and standardization scheme of the test procedure was presented.
Key Words: Smoke control, Performance based test procedure, Standardization


ABOUT
BROWSE ARTICLES
EDITORIAL POLICY
AUTHOR INFORMATION
Editorial Office
Room 906, The Korea Science Technology Center The first building, 22, Teheran-ro 7 Gil, Gangnam-gu, Seoul, Republic of Korea
Tel: +82-2-555-2450/+82-2-555-2452    Fax: +82-2-3453-5855    E-mail: kifse@hanmail.net                

Copyright © 2024 by Korean Institute of Fire Science and Engineering.

Developed in M2PI

Close layer
prev next